Operator`s manual

918496/GP0313 23
ANSI-Style and Common Safety Decal Locations (Cont.)
Note: Refer to Fig. 4 for decal locations.
WARNING
THE PROTECTION OFFERED BY THIS ROPS
WILL BE IMPAIRED IF IT HAS BEEN
SUBJECTED TO ANY MODIFICATION,
STRUCTURAL DAMAGE, OR HAS BEEN
INVOLVED IN AN OVERTURN INCIDENT, THIS
ROPS MUST BE REPLACED AFTER A ROLL-
OVER. SEAT BELTS MUST BE WORN WHILE
OPERATING VEHICLE.
201078
B
WARNING: Do not modify ROPS; replace damaged
ROPS; wear seat belt
• Located inside the ROPS structure.
• The protection offered by this ROPS will be
impaired if it has been subjected to any
modification, structural damage, or has been
involved in an overturn incident, this ROPS must
be replaced after a rollover. Seat belts must be
worn while operating vehicle.
C
WARNING: Crush Hazard
• Located on top of the articulation joint
on both sides.
• Keep away from machine when it is
being operated.
• Lock frames together when machine is
serviced or shipped.
D
USE DIESEL FUEL ONLY!
Located next to the fuel filler neck.
A
Lift Point Decal
• Located at the rear of the machine and near the
lift holes/rods near the top of the front frame.
• Apply lift hooks only in these location See
“Crane Lifting” on page 99.
E
Tie-down point, located on lift arm (front, both sides)
and frame (rear, both sides). Only use tie-down points
indicated on loader when transporting loader.
F
IMPORTANT
• Located next to the fuel filler neck.
• Use ONLY Low Sulfur Diesel (LSD) or
Ultra-Low Sulfur Diesel (ULSD) fuel.
• Use of diesel fuel with more than 500 PPM
of sulfur will damage the engine. See
“Fuel System” on page 116.