Instruction manual

3-47
3
STN
4: Remote Benchmark (RBM)
Determine the station elevation
Input the BM point and press the [ENT]
key. When the point is found in the
current or specified Control Job, it is
displayed.
After inputting the Height of Target, sight
the BM and press the [MSR] or [TRK]
key.
You can take F1/F2 measurements by
pressing the [4] key or just flipping the
telescope to Face2.
The coordinate of the station point is
displayed with the updated Z-coordinate.
The HI can be changed on this screen.
Z: The elevation of the station, calculated from the BM
point measurement.
Ｉｎｐｕｔ ＢＭ Ｐｏｉｎｔ
ＰＴ：■
ＨＴ： ２．１４００ｍ
ＣＤ：
1
･When the HI is changed, the Z-coordinate will be updated before
recording the station.
･If you have not already completed a station setup, the Remote
Benchmark function is not available. An error screen will be
shown. (See p.8-1, 3
rd
screen)
Ｘ： －１５４．２３１
Ｙ： ２３４５．３６２
Ｚ： １３５．３２５
ＨＩ： １．８１４０ ｍ
1
Ｓｉｇｈｔ ＢＭ
Ｐｒｅｓｓ ＭＳＲｏｒＴＲＫ
ＳＴＮ
Ｓｉｇｈｔ ＢＭ
ＶＤ： １．１１８４ｍ
ＨＤ： ８６．７５２１ｍ
ＳＴＮ Ｆ２
[MSR]
[ENT]
[F2] key is not available in DTM-330.