Instruction manual

3-3
3
Disp & Func
Initiates a TRK measurement and displays the result.
Holding down this key for a second displays its measure
mode settings (Target, Prism Const., Mode and AVE).
In the numeric input mode ( ), enters 3.
In the alpha-numeric input mode ( ), enters G, H, I, 3.
p.3-17
Displays the angle menu.
In the numeric input mode ( ), enters 4.
In the alpha-numeric input mode ( ), enters J, K, L, 4.
p.3-30
Displays the HOT menu.
While in Qcode observation mode, it has to be held down
for one second to activate the HOT menu.
In the numeric input mode ( ), enters 5.
In the alpha-numeric input mode ( ), enters M, N, O, 5.
p.3-25
Measures differences between remote target points.
In the numeric input mode ( ), enters 6.
In the alpha-numeric input mode ( ), enters P, Q, R, 6.
p.3-34
Measures the elevation difference between a prism target
point and an arbitrary point on a vertical line extending
from the target point.
In the numeric input mode ( ), enters 7.
In the alpha-numeric input mode ( ), enters S, T, U, 7.
p.3-36
Sets the station point (known point or arbitrary point).
In the numeric input mode ( ), enters 8.
In the alpha-numeric input mode ( ), enters V, W, X, 8.
p.3-37
Stakeout coordinates or pre-calculated angles/distances.
Holding this key for a second in Stakeout displays a S-O
related settings screen.
In the numeric input mode ( ), enters 9.
In the alpha-numeric input mode ( ), enters Y, Z, space, 9.
p.3-49
Enables observations without recording ST. HI, HT, Stn
coordinate, and BS azimuth can be input.
In the numeric input mode ( ), enters 0.
In the alpha-numeric input mode ( ), enters *, /, =, 0.
p.3-29
Proceeds to next screen. In the numeric or alpha-numeric
input mode, accepts the input data.
Also, on the BMS, outputs the current measurement data
(Pt/HA/VA/SD) via COM port when “Ext.Comms=Nikon”
is set.
1
A
TRK
3 ○
G
H
I
1
A
1
A
1
A
1
A
ANG
4 ○
J
K
L
HOT
5 ○
M
N
O
RDM
6 ○
P
Q
R
REM
7 ○
S
T
U
STN
8 ○
V
W
X
S-O
9 ○
Y
Z
*
／
＝
XYZ
0 ○
ENT
○
1
A
1
A
1
A