Instruction manual

iii
3
OPERATION
Staking out ..................................................................................... 3-49
1) Ang-Dist (HD-HA)............................................................................. 3-49
2) XYZ .................................................................................................... 3-52
3) 2-Pt Reference Line (2REF) .............................................................. 3-56
4) 2-Pt Reference Plane (V-Pln) ............................................................ 3-58
5) 3-Pt Reference Plane (S-Pln)............................................................. 3-60
6) Arc-curve Reference Line (Arc)......................................................... 3-62
Recording Measurement Data....................................................... 3-64
1) Recording data from any observation screen ................................... 3-64
2) Qcode.................................................................................................. 3-65
3) Offset Measurements ........................................................................ 3-67
3-1) Tape-Offset Measurements....................................................... 3-67
3-2) Angle-Offset Measurements ..................................................... 3-68
3-3) Two-Prism Pole Offset Measurements..................................... 3-69
3-4) Line extension by Horizontal Angle Offset .............................. 3-70
3-5) Corner Offset Measurements.................................................... 3-72
3-6) Slope distance extension........................................................... 3-74
3-7) Circle Offset Measurements ..................................................... 3-75
3-8) Horizontal distance input after Angle-only shot...................... 3-77
Using Various Functions (menu-key)............................................ 3-78
1) Job Manager............................................................................... 3-78
1-1) Opening an existing Job............................................................ 3-78
1-2) Creating a New Job................................................................... 3-79
1-3) Deleting Job............................................................................... 3-81
1-4) Control Job ................................................................................ 3-82
1-5) Displaying Job Information ...................................................... 3-83
2) Cogo.................................................................................................... 3-84
2-1) PT-PT Inverse ........................................................................... 3-84
2-2) HA+HD Coordinate................................................................... 3-85
2-3) Area & Perimeter ...................................................................... 3-86
2-4) Line and Offset.......................................................................... 3-87
2-5) Input Coordinate ....................................................................... 3-88
3) Sett..................................................................................................... 3-89
MENU
S-O
9 ○
Y
Z
REC
. ○
.
–
+