Instruction manual

8-1
8
ERROR MESSAGES AND ACTIONS
８ ERROR MESSAGES AND ACTIONS
1) When recording data:
The data storage is full.
Action : Press any key to return to the
BMS. Then, you need to delete
unnecessary data by entering
[MENU] [4:Data] or delete a
job via [MENU] [1:JOB].
A Job is not opened.
[1: Select Job]=goes to Job list if there is any existing job.
[2: Create Job]=displays a new job creating screen.
[3:Abort]/[ESC]=returns to the previous screen.
There is no Station record in the current
job. Or, a Station setup or BS check has
not been done since the program was
re-booted.
[1: Continue]=continues recording process after the
following comment. If a previously
recorded ST is in the job,
“CO, Use current
orientation”.
After inputting Stn coordinate
by [XYZ] key,
“CO, STN is changed by [XYZ]
key”.
[2: STN Setup]=goes to the STN menu.
[3:Abort]/[ESC]=returns to the previous screen.
ＤＡＴＡ ＦＵＬＬ
Ｐｒｅｓｓ ａｎｙ ｋｅｙ
！Ｎｏ Ｏｐｅｎ Ｊｏｂ
１：Ｓｅｌｅｃｔ Ｊｏｂ
２：Ｃｒｅａｔｅ Ｊｏｂ
３：Ａｂｏｒｔ
1
！Ｎｏ ＳＴＮ／ＢＳ Ｃｈｋ
１：Ｃｏｎｔｉｎｕｅ
２：ＳＴＮ Ｓｅｔｕｐ
３：Ａｂｏｒｔ
1