Instruction manual

4-4
4
CHECKING AND
ADJUSTMENT
2) Adjustment
Press the [MENU] and [7] key to enter
the calibration screen.
<DTM-350>
Take a F1 measurement to a target on
the horizon and press the [ENT] key.
Vertical angle is shown in “V0 dir=
Horiz” setting in this function.
V1: Face-left vertical angle (tilt-off value)
H1: Face-left horizontal angle (tilt-off value)
X1: Face-left X axis tilt value
Y1: Face-left Y axis tilt value
Upon finishing the measurement, the
message on the bottom line is changed
from “DO NOT TOUCH!” to “Turn to
FACE2”.
Take a F2 measurement to the same
target and press the [ENT] key.
V2: Face-right vertical angle (tilt-off value)
H2: Face-right horizontal angle (tilt-off value)
X2: Face-right X axis tilt value
Y2: Face-right Y axis tilt value
When the observation on F2 is completed
four parameters are displayed.
[1:Redo]/[ESC] returns to the first
observation screen.
[4:OK]/[ENT] sets those parameters on
the instrument.
１：Ｊｏｂ ５：Ｃｏｍｍｓ
２：Ｃｏｇｏ ６：Ｔｉｍｅ
３：Ｓｅｔｔ ７：Ｃａｌｉｂ
４：Ｄａｔａ ８：Ｎｏｔｅ
７
Ｘ： ７０″ Ｙ： －１０″
ＡＣＶ： ２３″
ＡＣＨ： ２０″
Ｒｅｄｏ ＯＫ
Ｘ１： ３８″Ｙ１： ５１″
Ｖ１： ０°２６′４０″
Ｈ１： ７９°００′５０″
Ａｉｍ Ｈｏｒｉｚ ＆ ＥＮＴ
Ｘ１： １８″Ｙ１： ２１″
Ｖ１： ０°２６′３４″
Ｈ１： ７９°００′５２″
Ｔｕｒｎ ｔｏ ＦＡＣＥ２
Ｘ２： １０″Ｙ２： －５５″
Ｖ２：１７９°３３′２５″
Ｈ２：２８１°０４′３０″
Ａｉｍ Ｈｏｒｉｚ ＆ ＥＮＴ