User Manual

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity. Check the unit for any damage, such as a misaligned

door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any

damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED

BY SHARP and repaired, if necessary.

2. Accessories provided

1) Turntable 2) Roller stay

3) Operation manual and Cooking guides

3. Fit the roller stay to the coupling located on the floor of the oven cavity. Place the turntable on the roller stay.

Make sure the turntable and roller stay are centrally located and locked together. Refer to OVEN DIAGRAM

on page 4. NEVER operate the oven without the roller stay and turntable.

4. The oven should not be installed in any area where excessive heat and steam are generated, for example,

next to a conventional oven unit.

The oven should be installed so as not to block ventilation openings.

Allow at least 15 cm on the top of the oven for free air space.

5. The A.C. voltage and frequency must be single phase 230-240V, 50Hz.

6. WARNING-THIS APPLIANCE MUST BE EARTHED.

If the socket outlet in your house is not compatible with the plug supplied, cut-off the mains plug and fit an

appropriate type, observing the wiring cord below.

If you are unsure how to do this get help from an electrician.

INPORTANT - The wires in power supply cord are coloured in accordance with the following code:

Green-and-yellow : Earth

Blue : Neutral

Brown : Live

As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured

marking identifying the terminals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked

with the letter E or by the earth symbol

or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or

coloured blue.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or

coloured brown.

NOTE: Under no circumstances should the cut-off plug be inserted into a socket outlet as a serious electric

shock may occur.