OVER THE RANGE MODELS R-1405, R-1406 Operation Manual

UNPACKING AND INSTALLATION INSTRUCTIONS

1. Remove and save 2 screws from back edge and 3 screws from the top center of the Fan Cover Bracket.

Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as

shown in Figure 11.

2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 12. CAUTION: Do not pull or stretch hood fan

wiring.

3. Rotate the Hood Fan Unit 90˚ so that the fan blade openings are facing the top of the oven. See Figure 13 (A).

Replace Hood Fan Unit into the oven. Be careful not to pinch the lead wire between the inner bracket and the

Hood Fan Unit. Put the lead wire into Wire Box. See Figure 13 (B).

4. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan Cover

Bracket. Make sure the fan blades are visible through the top openings in the oven before proceeding.

5. Attach the Fan Cover Bracket to unit with the 2 screws from back edge and 3 screws from the top center of the

Fan Cover Bracket, which were removed in Step 1 above. See Figure 14. The Hood Fan Unit is now rotated for

vertical exhaust operation.

6. Attach the Exhaust Damper Assembly 9 to the fan cover on the top of the outercase cabinet by sliding it into the

slits in the same direction as the arrow. Use 1 Tapping Screw 4 X12 mm 5 from the INSTALLATION HARD-

WARE and tighten into place. See Figure 15.

Figure 13

Exhaust Damper Assembly

Figure 15

Figure 11

Figure 12

(A) Rotate 90˚

Figure 14

(B)

R-1405/06-B318 7/15/02, 9:54 AM11