Projector Remote Control setup guide

Using Video Output in Room 111 - Step-by-Step

Instructions for using the Room 111 mounted projectors to display images and output sound from

the room's VHS video recorder/player, the U-Matic video player, and the laserdisc player.

0.0 Initial setup

0.1 Look on the south wall (the wall with the whiteboard on it). On the left-

hand side is a set of light switches [see Figure A].

Figure A

screens

I I

These switches are

for bringing the right

and left projector

screens down.

These switches This switch

turn the dims and

Fl u o resce nt brightens the

lights on and off. oval ceiling

lights

1.0 On PRIMARY CONTROL (Console #1)

This provides power to all of the components in the console, and to the ceiling speakers. It does

not control power to the projector. The volume knobs control the ceiling speakers.

1.1 Select Power ON (button lit).

1.2 Select Ceiling speakers ON (button lit).

2.0 On RECEIVER (Console #1)

The Receiver works in tandem with the Switcher (see next step) where you choose the source of

the image and/or sound to be projected. The volume knob on the Receiver controls the speakers

at the front of the room.

2.1 RECEIVER should be ON (text is shown in display window).

2.2 Select SWITCHER button (displayed text: DVD/TV).

3.0 On SWITCHER (Console #1) /see Image below and Figure Al

Here you first select the source of the video to be projected, either VCR1, VCR2, or LDP1. Then

you select which projector will display the image from computer, either PROJ1A/IDEO,

PROJ2A/IDEO, or BOTH). You also use the Switcher to output sound.