Projector Remote Control setup guide

Macintosh
o
o
T
Network
connection
Extension from cpu
connects here (adapter
needed)
0.5 Connect the extension that is attached to the monitor cable to the
shorter length of the split dark, gray cable.
0.6 Connect the other side of the split, dark gray cable to CPU1 or CPU2.
0.7 Once all cables are connected, turn on workstation and monitor.
1.0 On PRIMARY CONTROL (Console #1)
This provides power to all of the components in the console, and to the ceiling
speakers. It does not control power to the projector. The volume knobs control
the ceiling speakers.
1.1 Select Power ON (button lit).
1.2 Select Ceiling speakers ON (button lit).
2.0 On RECEIVER (Console #1)
The Receiver works in tandem with the Switcher (see next step) where you
choose the source of the image and/or sound to be projected. The volume knob
on the Receiver controls the speakers at the front of the room.
2.1 RECEIVER should be ON (text is shown in display window).
2.2 Select SWITCHER button (displayed text: DVD/TV).
3.0 On SWITCHER (Console #1) [see Image below and Figure Cl
Here you first select the source of the computer image to be projected, either
CPU1 or CPU2. Then you select which projector will display the image from
14