Setup Manual
8
E
• When installing, removing or moving the monitor, ensure that this is carried out by at least 2 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm) longer than the
thickness of the mounting bracket.
Screw (M6)
Mounting bracket
Monitor mounting
3/8 - 1/2 inch (10 - 12 mm)
• Do not use an impact driver.
• When moving the monitor, be sure to hold it around the periphery. Do not grasp the screen. This may cause product damage,
failure, or injury.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation.
• When using the monitor laying at on a surface (when the monitor is tilted 20 degrees or more upward or downward from the
perpendicular in relation to a level surface), consult an authorized SHARP dealer because there are some specic mounting
conditions.
n
Operation mode
When the monitor is turned on for the rst time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 is the recommended setting and conforms to
the “Normal Conguration” as dened in the EcoDesign
Regulation (2019/2021).
MODE1 ....POWER MANAGEMENT setting can not be
changed. If there is no signal for approx. 5 minutes,
this monitor automatically enters standby mode.
OFF IF NO OPERATION and POWER SAVE
MODE are set to ON.
These settings can not be changed.
If there is no operation for 4 hours or more, this
monitor automatically enters standby mode. Power
consumption in standby state is also minimized.
MODE2 ....POWER MANAGEMENT is set to ON.
OFF IF NO OPERATION and POWER SAVE
MODE are set to OFF.
These settings can be changed.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)
n
Date/time setting
• If the time has yet to be set when the monitor is rst turned
on, the date/time setting screen appears. Set the date and
time.
• Be sure to set the date and time.
Mounting Precautions
(For SHARP dealers and service engineers)