PN-E471R/E421 Setup-Guide GB

5
E
Basic Operation
1
2
3
4
5
6
7
8
1. INPUT (Input mode selection)
The menu is displayed. Press
or to select the input
mode, and press
to enter.
* You can select the input terminal by pressing the input
switch of the monitor.
Input mode Video Audio
PC D-SUB PC D-sub input terminal
Audio input terminal
PC HDMI
PC/AV HDMI input terminal
*1
*2
AV HDMI
PC/AV HDMI input terminal
*1
When the PN-ZB01 (optional) is attached
Input mode Video Audio
PC DVI-D
PC/AV DVI-D input terminal
*3
*2
PC HDMI
PC/AV HDMI input terminal
*1
PC D-SUB
PC D-sub input terminal
PC RGB
PC RGB input terminals
*4
AV DVI-D
PC/AV DVI-D input terminal
*3
AV HDMI
PC/AV HDMI input terminal
*1
AV COMPONENT
AV COMPONENT input terminals
*4
AV S-VIDEO AV S-video input terminal
AV VIDEO AV video input terminal
*1 Select the terminal to be used in HDMI of INPUT SELECT.
(See page 12.)
*2 Select the terminal for AUDIO SELECT which is used for
audio input. (See page 12.)
*3 Select the terminal to be used in DVI of INPUT SELECT.
(See page 12.)
*4 Select the terminal to be used in BNC of INPUT SELECT.
(See page 12.)
2. DISPLAY
Displays monitor information. When you press this button
again, the display disappears.
When the PN-ZB01 (optional) is attached, the display changes
from INFORMATION1 → INFORMATION2 → clear display,
and so on every time you press this button.
The display disappears automatically after about 15
seconds.
LAN
is displayed during LAN communication.
If
LAN
is displayed in red, there is a duplicate IP address.
3. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB → STD...
sRGB applies to PC input only.
sRGB is international standard of color representation
specied by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal’s characteristics and represents color tone
close to its original image.
4. SIZE (Screen size selection)
The menu is displayed.
Press
or to select the screen size. (See page 6.)
5. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
6. MENU
Displays and turns off the menu screen (see page 7).
7. VOL +/- (Volume adjustment)
Pressing
or displays the VOLUME menu when the
menu screen is not displayed.
Press or to adjust the volume of the sound.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.
8. BRIGHT +/- (Backlight adjustment)
Pressing
or displays the BRIGHT menu when the menu
screen is not displayed.
Press or to adjust the brightness.
* If you do not press any buttons for about 4 seconds, the
BRIGHT menu automatically disappears.