Operation Manual WIRELESS CONTROLLER

30
E
You can enable starting of the connection software from a commercially available USB ash drive.
USB ash drives that can be used:
• USB ash drives indicated on page 5 with a capacity of 128 MB or more.
• Use a USB ash drive in which nothing is saved.
1. Insert the USB ash drive into the USB port of the wireless controller.
2. Touch “Setup” ( ) in the home screen of Wireless mode.
3. Touch “Make Token”.
Making starts.
4. When the making completed message appears, remove the USB ash drive.
Caution
• Do not remove the USB ash drive while making is in progress.
And do not turn off the power of the monitor.
• Always create this on the wireless controller.
Incorrect operation will result if you copy the le from the wireless token to the USB ash drive using your computer.
TIPS
• When the USB ash drive connection software is started, the software will automatically connect to the wireless controller on
which the wireless token was created. (The software will also connect automatically over wireless LAN.)
Starting from a commercially available
USB ash drive