Projector User Manual

E-11
Using the Image Invert/Reverse Function
This projector is equipped with an image invert/reverse function. The projected image can be inverted or reversed
by using the MENU button and the ADJUSTMENT ƒ/∂ and ß/© buttons.
1
BLK SCRN DISP
IMAGE ADJ.
REVERSE
INVERT
INPUT DISPLAY
[
OFF
]
[
OFF
]
[
OFF
]
[
OFF
]
:SEL.
:ADJ.
:END
MENU
BLK SCRN DISP
IMAGE ADJ.
REVERSE
INVERT
INPUT DISPLAY
[
OFF
]
[
ON
]
[
OFF
]
[
OFF
]
:SEL.
:ADJ.
:END
MENU
2
2. Reversed Image Mode
In the “IMAGE ADJ.” menu, press the
ADJUSTMENT ƒ/∂ buttons to select “REVERSE”.
Then press the ADJUSTMENT ß/© buttons to
select “ON”. The reversed image will appear.
BLK SCRN DISP
IMAGE ADJ.
REVERSE
INVERT
INPUT DISPLAY
[
OFF
]
[
OFF
]
[
ON
]
[
OFF
]
:SEL.
:ADJ.
:END
MENU
3
3. Inverted Image Mode
In the “IMAGE ADJ.” menu, press the
ADJUSTMENT ƒ/∂ buttons to select “INVERT”.
Then press the ADJUSTMENT ß/© buttons to
select “ON”. The inverted image will appear.
BLK SCRN DISP
IMAGE ADJ.
REVERSE
INVERT
INPUT DISPLAY
[
OFF
]
[
ON
]
[
ON
]
[
OFF
]
:SEL.
:ADJ.
:END
MENU
4
4. Reversed Inverted Image Mode
In the “IMAGE ADJ.” menu, set the “REVERSE” and
“INVERT” functions to “ON”. The reversed inverted
image will appear.
5. Press the MENU button anytime to exit
“IMAGE ADJ.”
1. Press the MENU button
With the MENU screen displayed, press the AD-
JUSTMENT ƒ/∂ buttons to select “IMAGE ADJ.”.
Then press the ENTER button to display the
“IMAGE ADJ.” screen.
• The last MENU screen selected is indicated for about
30 seconds.
Cautions: When setting up the projector
• For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed
in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environ-
ments, the lens and filter must be cleaned more often. Periodically the filter should be replaced and the pro-
jector should be cleaned internally. As long as the projector is properly maintained in this manner, use in these
environments will not reduce the overall operation life. Please note that all internal cleaning must be performed
by an Authorized Sharp Industrial LCD Products Dealer or Service Center.
• Do not expose to extreme heat or cold.
Operating temperature: 41°F to 104°F (`5°C to `40°C)
Storage temperature: 14°F to 140°F (120°C to `60°C)
• Do not tilt the projector more than 5°.
How to set up the projector and screen
• Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes
out colors, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or
sunny room.
• The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector
and screen as shown.
On-Screen Display