Operation Manual, User's Manual

8-132
SYSTEM SETTINGS►SYSTEM SETTINGS
Paper Type for Auto Paper Selection
The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings:
• Plain Paper 1
• Plain Paper 2
•Recycled
The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting.
* The paper type set for each paper tray by selecting [System Settings] in "Settings" → [Paper Tray Settings].
Plain Paper Compatibility Settings
Set the weight of the plain paper that is regularly used. Select from Plain Paper 1 or Plain Paper 2.
The weight of Plain Paper 1 is 60 to 89 g/m
2
(16 to 24 lbs bond). The weight of Plain Paper 2 is 90 to 105 g/m
2
(24 to 28
lbs bond). Check the weight of the plain paper that you regularly use, and set accordingly.
Tandem Connection Setting
When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number
and IP address of the machine used as the tandem client machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting. (Normally this setting is not necessary.)
Disabling of Client Machine Mode
To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.)
Detect Standard in Auto Colour Mode
When the colour mode is set to auto in image send mode, the discrimination point for detecting whether originals are
colour or black and white can be set to one of 5 levels. When set to [Closer to B/W], the originals are easier to recognize
as black and white. When set to [Closer colour], the originals are easier to recognize as black and white.
Total Setting for Finish
Select the finish setting. Set whether finishing positions are specified on the specified paper or on the original.
Paper Weight Setting
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, coloured
paper, and user type paper.
You can select "60g/m
2
to 89g/m
2
" or "90g/m
2
to 105g/m
2
" ("16 to 23 lbs." or "23+ to 28 lbs.").
• To use the tandem function when user authentication is enabled, the same login name and password must be used on
both the master machine and client machine. If the same login name and password are not used, the page count may not
be added to the appropriate user count or only the master machine may print.
• The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change
the port number.
This can only be set on the machine's operation panel.
Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that
is outside the range with the paper in the tray.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER (page 1-10)
".