Operation Manual, User's Manual

5-114
SCANNER/INTERNET FAX►OTHER FUNCTIONS
STAMPING SCANNED ORIGINALS (VERIFICATION STAMP)
This function stamps each original that is scanned using the automatic document feeder, allowing you to verify that all
originals were correctly scanned.
• To use the verification stamp function, the optional stamp unit must be installed.
• When 2-sided originals are used, the front of each original is stamped twice.
• If an error occurs during scanning, an original that was not scanned may be stamped.
• When the "O" mark that is stamped on originals starts to become faint, replace the stamp cartridge.
For the procedure for replacing the stamp cartridge, see "REPLACING THE STAMP CARTRIDGE
(page 1-166)".
1
Place originals in the automatic document feeder.
When in fax mode, then after completing this procedure, proceed to Step 3.
► AUTOMATIC DOCUMENT FEEDER
(page 1-116)
2
Tap the mode display to switch to the initial screen of each mode.
► CHANGING MODES (page 1-15)
3
Specify the destination.
► RETRIEVING A DESTINATION FROM AN ADDRESS BOOK (page 5-15)
► VIEWING A LIST OF THE SELECTED DESTINATIONS (page 5-18)
► USING A SEARCH NUMBER TO RETRIEVE A DESTINATION (page 5-19)
► ENTERING AN ADDRESS MANUALLY (page 5-20)
► SPECIFYING A NETWORK FOLDER (page 5-21)
► RETRIEVING A DESTINATION FROM A GLOBAL ADDRESS BOOK (page 5-23)
► USING A TRANSMISSION LOG TO RESEND (page 5-25)
When in fax mode, enter the destination number.
► ENTERING A DESTINATION NUMBER USING THE NUMERIC KEYS
(page 4-12)
► RETRIEVING A DESTINATION FROM AN ADDRESS BOOK (page 4-14)
► USING A SEARCH NUMBER TO RETRIEVE A DESTINATION (page 4-17)
► RETRIEVING A DESTINATION FROM A GLOBAL ADDRESS BOOK (page 4-18)
► USING A TRANSMISSION LOG TO RESEND (page 4-20)
11
Originals Originals are
scanned
An "O" mark is
stamped in
fluorescent pink.
Position of stamp