Operation Manual, User's Manual

7-94
SETTING MODE►SYSTEM SETTINGS
TRAP Community
Enter the community name to be used for the SNMP TRAP sent from the device.
TRAP Target Address
Enter the IP address of the destination computer for SNMP TRAP communication.
SNMP v3 Settings
SNMP v3 Settings
Set this option to use the SNMPv3 settings.
User Name
Enter the user name.
Authentication Key
Enter the authentication key.
Privacy Key
Enter the privacy key.
Context Name
Display the context name.
SMB Settings
Set the version of SMB protocol that is used for functions such as Scan to Network Folder.
Use this setting to connect to a device that cannot automatically change the SMB protocol version, or when there is a
problem in the connection with another device due to different versions.
Set the version to SMB2.0, SMB2.1, or SMB3.0.
Print Port Settings
LPD
Enter a profile expiring date.
LPD Settings
LPD
Set this option to use LPD.
Timeout
Enter a timeout. The default setting is 90 seconds.
Use Banner
Set this option to use the banner. The default setting is "Invalid".
RAW
Raw Print Settings
Raw Print
Set this option to use Raw printing. The default setting is "Valid".
Port Number
Enter a port number. The default setting is port 9100.
Timeout
Enter a timeout. The default setting is 90 seconds.
Use Bidirectional
To use bidirectional communication, set to .
• One of the settings is SMB1.0, however, this is always enabled and cannot be disabled.
• When a version is disabled, version settings higher than that version are all disabled. When a version is enabled, all
version settings lower than that version are enabled.