M310 Operation-Manual Online-Manual GB

Table Of Contents

TROUBLESHOOTING

CONTENTS

Print quality is not satisfactory

(part 2)

Part of the printed image is missing

■ Did you set sufficient margins in the paper settings

of your application?

Printing is not possible at the edges of the paper. The print

margins are 5/32" (4 mm) at the top and bottom of the paper

and 1/8" (3 mm) at the sides of the paper. When configuring the

paper settings in the software application, be sure to establish

margins that are at least as large as the print margins.

■ Does the paper size set for the print image match the

size of paper loaded in the machine?

Make sure that the paper size setting matches the size of

paper loaded in the machine. When "Auto Select" is selected

for the paper source in the print settings, the print method will

vary depending on the settings of the system settings

(administrator).

☞Windows: When "Paper Selection" is set to "Auto Select"

☞Macintosh: When "Paper Feed" is set to "Auto Select"

■ Are the print orientation settings correct?

Make sure that the correct paper orientation is selected for

the print image in the application's paper settings and in the

print settings.

If the paper is loaded in the machine in a different orientation

from the print image, the image is normally automatically

rotated to match the paper; however, if this function has been

disabled in the system settings (administrator), the paper

orientation must be set in the application. (See "ROTATED

PRINT" in the "SYSTEM SETTINGS (ADMINISTRATOR)" in

the operation manual.)