Operation Manual, User's Manual

4-43
FACSIMILE►CONVENIENT FAX FUNCTIONS
STORING, EDITING AND DELETING PROGRAMS
You can store a address setting, transmission method*, original size enter, duplex scanning, resolution and exposure,
own number sending, transmission settings.
This will allow you to use the settings for a transmission by means of a simple operation (see USING SETTINGS
STORED AS A PROGRAM (page 4-49)).
* Transmission methods: normal transmission, broadcast transmission, polling, serial polling.
To register a program, perform the steps below in the auto dial storing screen.
Storing a program
A screen setting and timer transmission setting cannot be stored in a program.
1
Select "Entry" and select "Register Program" with the [ ] or [ ] key.
2
Select "Enter", "Change", or "Delete" with the [ ] or [ ]
key.
• To store a program, select "Enter" and press the [OK] key.
Continue from step 3 of Storing a program (page 4-43)
.
•
To edit a program, select "Change" and press the [OK] key.
Next, follow the steps in Editing programs (page 4-44)
.
• To delete a program, select "Delete" and press the [OK] key.
Next, follow the steps in Deleting programs (page 4-44)
.
3
Select the program that you wish to store with the [ ] or [ ] key, and enter
the program name. (see CHARACTER ENTRY
(page 1-39))
If you select a program that has already been stored, a message appears. Select a program that has not been stored, or
clear the program (►page 4-44)
and then select it.
4
Select the item that you wish to store in the program
with the [ ] or [ ] key.
• A transmission method, original size enter, dual pages, resolution/exposure settings,
sender's name, and transmission settings can be stored.
• A transmission method must be stored. The storing procedure cannot be completed
unless a transmission method is stored.
• For the procedures for selecting each of the settings, refer to the explanations of the
settings.
• To cancel a setting selection, select the setting that you wish to cancel and then press
the key.
• Some settings cannot be used in combination with others. If you select a prohibited
combination of settings, a message will appear in the display.