Operation Manual, User's Manual

7-122
SYSTEM SETTINGS►SYSTEM SETTINGS
Paper Type for Auto Paper Selection
The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings:
• Plain Paper 1
• Plain Paper 2
•Recycled
The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting.
* The paper type set for each paper tray by selecting [System Settings] in "Settings" → [Paper Tray Settings].
Plain Paper Compatibility Settings
Set the weight of the plain paper that is regularly used. Select from Plain Paper 1 or Plain Paper 2.
The weight of Plain Paper 1 is 60 to 89 g/m
2
(16 to 24 lbs bond). The weight of Plain Paper 2 is 90 to 105 g/m
2
(24 to 28
lbs bond). Check the weight of the plain paper that you regularly use, and set accordingly.
Tandem Connection Setting
When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number
and IP address of the machine used as the tandem client machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting. (Normally this setting is not necessary.)
Disabling of Client Machine Mode
To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.)
Detect Standard in Auto Colour Mode
When the colour mode is set to auto in colour mode/image send mode, the discrimination point for detecting whether
originals are colour or black and white can be set to one of 5 levels. When set to [Closer to B/W], the originals are easier
to recognize as black and white. When set to [Closer colour], the originals are easier to recognize as black and white.
Status Indicator Setting
The status indicator on the back of the machine lights up or blinks according to the status of the machine.
You can change this setting to specify the machine status that causes the green indicator (status indicator) to light up or
blink. The indicator goes off when Auto Power Shut-Off is enabled.
Green indicator (Status indicator) : You can specify which job management and original scanning status respectively
cause the indicator to light up and blink.
Red indicator (Error indicator) : This indicator lights up or blinks when an error occurs on the machine.
Red indicator (Error indicator) lights up and blinks the same way regardless of the pattern you select.
• To use the tandem function when user authentication is enabled, the same login name and password must be used on
both the master machine and client machine. If the same login name and password are not used, the page count may not
be added to the appropriate user count or only the master machine may print.
• The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change
the port number.
Status Pattern 1 Pattern 2 Pattern 3
Green
indicator
(Status
indicator)
Job in progress, such as paper
feeding or output.
Green: Light up - -
Ready state or other state
where jobs can be accepted.
- Green: Light up -
An original has been placed in
the document feeder.
- - Green: Light up
The machine is in a status other
than the above.
Green: Off Green: Off Green: Off