Operation Manual, Setup Guide for the Administrator, GB

20
2.2.2 Scan Original Edge Adjustment (Duplex
Single Pass Feeder)
This performs edge (scanning start) position adjustment
for scanning original from document feeder.
1) Select [Scan Original Edge Adjustment (Duplex Single
Pass Feeder)] in the Edge Adjustment screen.
Specify the Print Position Adjustment first.
2) Enter the desired values and tap the [Register] key.
Input range: [20] to [80] (1 = 0.1 mm)
Default: [50] for each
Note:
To return your preferences to the factory defaults, tap
the [Return Original Scan Edge Adjustment Value
(Duplex Single Pass Feeder) to Default] key. When a
confirmation message appears, tap the [OK] key. Your
preferences are returned to the factory defaults and
the screen returns to the Edge Adjustment screen.
2.3 Void Area Adjustment
Select [Void Area Adjustment] in the Image
Position/Ratio/Area Adjustment screen.
2.3.1 Copy Image Loss Amount Settings
This performs adjustment of image loss amount for
scanning original in copy mode.
1) Select [Copy Image Loss Amount Settings] in the Void
Area Adjustment screen.
Specify the Print Position Adjustment first.
2) Enter the desired values and tap the [Register] key.
Input range: [0] to [99] (1 = 0.1 mm)
Defaults:
Edge image loss amount setting: [40]
Side image loss amount setting: [20]
Note:
To return your preferences to the factory defaults, tap
the [Return Copy Image Loss Amount Settings to the
Default] key. When a confirmation message appears,
tap the [OK] key. Your preferences are returned to the
factory defaults and the screen returns to the Void
Area Adjustment screen.
2.3.2 Print Void Settings
This performs adjustment of print void amount for printing.
1) Select [Print Void Settings] in the Void Area Adjustment
screen.
2) Enter the desired values and tap the [Register] key.
Input range: [0] to [99] (1 = 0.1 mm)
Defaults:
Print Lead Edge Void Amount Adjustment: [40] to [99]
Print Rear Edge Void Amount Adjustment: [30] to [99]
FRONT/REAR Void Amount Adjustment: [20]