MX-2010U/2310U Operation-Manual GB

2-115
COPIER
Contents
REVERSING WHITE AND BLACK IN A COPY (B/W Reverse)
This is used to reverse black and white in a copy to create a negative image. This function can only be used for black
and white copying.
Originals with large black areas (which use a large amount of toner) can be copied using Black/White Reverse to reduce
toner consumption.
1
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
2
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the keys to switch through the screens.
(3) Touch the [Image Edit] key.
☞ [Image Edit] KEY (page 2-104)
3
Select B/W Reverse.
(1) Touch the [B/W Reverse] key so that it is
highlighted.
(2) Touch the [OK] key.
You will return to the special modes screen. Touch the
[OK] key to return to the base screen of copy mode.
4
Press the [BLACK & WHITE START] key.
Copying will begin.
If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you
have selected sort mode, change originals and press the [BLACK & WHITE START] key. Repeat until all pages have been
scanned and then touch the [Read-End] key.
When using this function, the [COLOUR START] key cannot be used.
To cancel scanning and copying...
Press the [STOP] key ( ).
Originals B/W Reverse copy
A3
Full Bleed
OK
Mirror
Image
B/W
Reverse
Multi-Page
Enlargement
Centring
Photo Repeat
Special Modes
Image Edit
OK
(1) (2)