Government Compliance

Page 11 of 16
and lower than 55 Hz.
Applicable.
Criteria
Supporting Features
Remarks and explanations
(j)Products which are freestanding, non-portable, and
intended to be used in one location and which have
operable controls shall comply with the following:
(1) The position of any operable control shall be
determined with respect to a vertical plane, which is
48 inches in length, centered on the operable control,
and at the maximum protrusion of the product within
the 48 inch length (see Figure 1 of this part).
Supports Applicable
(j)(2) Products which are freestanding, non-portable,
and intended to be used in one location and which
have operable controls shall comply with the
following: Where any operable control is 10 inches or
less behind the reference plane, the height shall be
54 inches maximum and 15 inches minimum above
the floor.
Supports (For
MX6240N/7040N)
Not Support (For
MX6500/7500N)
Applicable.
(j)(3) Products which are freestanding, non-portable,
and intended to be used in one location and which
have operable controls shall comply with the
following: Where any operable control is more than 10
inches and not more than 24 inches behind the
reference plane, the height shall be 46 inches
maximum and 15 inches minimum above the floor.
(j)(4) Products which are freestanding, non-portable,
and intended to be used in one location and which
have operable controls shall comply with the
following: Operable
controls shall not be more than 24
inches behind the reference plane.
Return to the top of the page.