Operation Manual

1-31
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
MOTION SENSOR (MX-3070N/MX-3570N/MX-4070N/
MX-5070N/MX-6070N only)
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode (Motion Sensor Mode Only).
Three settings are available for the detection range ( / / ).
• When a finisher (large stacker) or saddle stitch finisher (large stacker) is installed on the MX-5070N/MX-6070N, open the
front cover on the finisher (large stacker), or the front upper cover on the saddle stitch finisher (large stacker), before
opening the front cover of the machine.
• The motion sensor detects the movement of sources of heat.
• The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
The motion sensor may not operate correctly in the conditions below.
• An object is in front of the motion sensor
• There are scratches or dirt on the motion sensor cover
• The motion sensor is directly exposed to sunlight or air flow
• The motion sensor is damaged
• There is a source of heat such as a heater nearby
• An object is moving in the detection range
To enable the motion sensor
"Settings (administrator)" select [System Settings] → [Energy Save] → [Eco Setting] → [Sleep Mode Power Level].
Motion sensor
Near Far
Detection range
Approx.
maximum
1.5 m
60 degrees