Instruction manual

2 SafeCom Controller

D60700-07

2.8.18 Control FTP and TELNET network access

By default the SafeCom Controller can be accessed via FTP to update software

(2.9.1) and via TELNET to do troubleshooting if instructed to do so by support

personnel. To disable these network access methods follow these steps:

1. Open the Advanced Configuration web page (2.7.2).

2. Click General and scroll to Network Access.

3. Change Enable FTP access to No.

4. Change Enable TELNET access to No.

5. Click Save and Continue.

6. Click Restart.

2.9 SafeCom Controller update software

1. Download the file(s) from the links supplied to you. Unzip the files. There

are one current and two obsolete types of SafeCom Controllers:

 SafeCom Controller (p/n 10401x)

Features a built-in 2-port switch (no need for additional network

outlet). Supports full-duplex transmission.

Unzipped file: 508nnn.b80, where nnn is the version.

 SafeCom Controller 3 Port (obsolete)

Features a built-in 3-port hub (no need for additional network

outlet). Supports half-duplex, but not full-duplex transmission.

Unzipped file: 312nnn.b80, where nnn is the version.

 SafeCom Controller 1 Port (obsolete)

Features one network port, but supports full-duplex transmission.

Unzipped file: 304nnn.b80, where nnn is the version.

2. Download the software file to the SafeCom Controller using one of the

following methods:

 SafeCom Administrator

 FTP (2.9.1)

 Mini-FTP (2.9.2)