Instruction manual

1 Introduction
D60700-07
13
Xerox
SafeCom
MFP cable
p/n
Notes
Xerox WorkCentre Pro
C2128, C2636, C3545
AB
962010
SafeCom Controller and
Xerox Foreign Interface Kit.
Xerox p/n 098S04822.
Xerox DocuColor
12, 240, 250, 1632, 2240,
3535
Xerox WorkCentre
M24, M118, M123, M128,
M133
AB
962010
SafeCom Controller and
Xerox Foreign Interface Kit.
Xerox p/n 498K14140.
Xerox WorkCentre Pro
123, 128, 133
AB
962010
SafeCom Controller and
Xerox Foreign Interface Kit.
Xerox p/n 497K02202.
Note: Unless mentioned explicitly the MFPs can only report the number of
copied pages and does not provide information about paper size or use of color
and duplex.
A Supports paper size and duplex information.
B Supports color detection on a per copy page basis.
C Page counter is updated at end of copy job and after every 50 or 100 pages
depending on model.
D Page counter is updated at end of copy job.
Note: Some of the MFPs that are unable to provide information about paper
size or use of color try to compensate for this lack of detail by reporting a
higher number of copied pages. One popular method is to report that two
pages are copied when actually one monochrome A3 page or one color A4 page
is copied. Likewise one color A3 page would be reported as 4 pages.
When a SafeCom Controller and stand-alone card reader is used, copying can
begin only after any pending Pull Print jobs have been printed. If a SafeCom
Front-end is attached the user is free to log in to copy, print or both.