Flat Panel Television User Manual

LD-14115-16
10. Handling Precautions
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or
twist.
c) Since the front polarize is easily damaged, pay attention not to scratch it.
d) Since long contact with water may cause discoloration or spots, wipe off water drop immediately.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with
care.
g) Since CMOS LSI is used in this module, take care of static electricity and take the human earth into
consideration when handling.
h) Make sure the mounting holes of the module are grounded sufficiently. Take electro-magnetic interference
(EMI) into consideration.
i) The module has some printed circuit boards (PCBs) on the back side. Take care to keep them form any
stress or pressure when handling or installing the module; otherwise some of electronic parts on the PCBs
may be damaged.
j) Observe all other precautionary requirements in handling components.
k) When some pressure is added onto the module from rear side constantly, it causes display non-uniformity
issue , functional defect, etc. So, please avoid such design.
l) If the stress is applied onto the panel under operating conditions, display defects such as black dots may
occur. So, do not press the display with fingers.
To recover this defect, turn off the power supply and restart after several seconds.
11. Packing form
a) Piling number of cartons : maximum 8 cartons
b) Packing quantity in one carton : 2 module
c) Carton size : 592mm(W) × 486mm(H) × 215(D)
d) Total mass of one carton filled with full modules : 10.5kg
e) Packing form is shown in Fig.3