Specifications

5
Attaching the stand unit
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect
installation of the stand may result in the TV falling
over.
1 Confirm that there are screws with the stand
unit.
1 For 60 inch models
(four long screws, five middle screws and two
short screws)
2 For 52 inch models
(four long screws, four middle screws and one
short screw)
2 Attach the supporting post for the stand unit
onto the base using the long screws with a
screwdriver as shown.
Supporting
post

60 inch models

52 inch models
3 Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion

60 inch models

52 inch models
4 Insert and tighten middle screws into the holes
on the rear of the TV.

60 inch models

52 inch models
5 Attaching the stand cover.
1 Insert the stand cover.
2 Insert and tighten the short screw(s) into the
hole(s) of the stand cover.

60 inch models

52 inch models
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• The TV can be rotated up to 20 degrees to the right and
left.
Preparation