Operating instructions

14
Watching TV
Simple operations for watching a TV program
Antennas
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV.
NOTE
• The antenna and the cable converter cannot be connected at the same time.
1. A 75-ohm system is generally a round cable with F-type
connector that can easily be attached to a terminal without
tools (Commercially available).
2. A 300-ohm system is a flat “twin-lead” cable that can be
attached to a 75-ohm terminal through a 300/75-ohm
adapter (Commercially available).
F-type connector
75-ohm coaxial cable (round)
300-ohm twin-lead cable (flat)
F-type connector
75-ohm coaxial cable
When connecting the antenna cable to the TV set, do not
tighten F-type connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
F-type connector should be finger-tightened only.
NOTICE
POWER
Turning on the power
Off
Green
Display status indicator
Power off/standby
The TV is on.
POWER indicator
Press POWER on the TV, or TV POWER on the remote control.
• POWER indicator (Green): The TV is on. (After a few seconds, a window
appears with sound.)
NOTE
• The initial setup starts when the TV powers on for the first time. If the TV
has been turned on before, the initial setup will not be invoked. See page
20 to try EZ setup from the Setup menu.
Turning off the power
Press POWER on the TV, or TV POWER on the remote control.
• The TV enters standby mode and the image on the screen disappears.
• The POWER indicator on the TV gradually turns off.
NOTE
• If you are not going to use this TV for a long period of time, be sure to
remove the AC cord from the power outlet.
• Weak electric power is still consumed even when POWER is turned off.
TV POWER (On/Standby)
LC-26/32GA5U(E)-14-18 05.2.28, 1:10 PM14