Operation Manual

14
Using the Menu screen
You need to call up the OSD to perform settings for the TV. The OSD for the
settings is called “Menu”. The “Menu” enables various settings and adjustments.
Display the Menu screen
n
Go to “TV Menu”.
• You can also display the Menu screen via the HOME menu screen (Page 13).
Selecting in the Menu
n
Press c/d to select the desired menu,
and then press ;. Press 6 to return to
the previous menu category.
o
Press c/d to select the desired sub-
menu, and then press ;.
p
Press a/b to select the item you want to
select/adjust, and then press ;.
Setup
Backlight
AV mode
Picture
OPC
[Off]
CH list
:Back:Enter
Menu
3D brightness boost
[Middle]
Selecting options
q
Press a/b or c/d to
configure the control for
improving TV viewing, and
then press ;.
EXAMPLE
Backlight
Yes No
NOTE
• Refer to the guide display
below the menu bar to see
when to press the ; button.
About the guide display
The guide display below the menu bar shows
operations for the OSD.
• The bar above is an operational guide for the
remote control unit. The bar will change in
accordance with each menu setting screen.
SetupCH list
:Back:Enter
:Select
NOTE
• “Menu” options differ according to the selected input modes, but the operating
procedures are the same.
• Items with 4 cannot be selected for various reasons.
• Some items cannot be selected depending on signal types, optional settings or
connected devices.
Using Software keyboard
Use the software keyboard when you need to input text.
Char.Set
Caps
Done
Cancel
SP
Delete
Clear
Cursor Left Caps Char.Set Cursor Right
1
8
76
2
3
4
9
10
11
5
1 Char. Set
Changes character
set into the alphabet,
numbers, symbols, etc.
2 Caps
Changes characters to
capital/lower case.
3 Done
Confirm the entry.
4 Cancel
Abort input and close
the software keyboard.
5 R/G/Y/B (Colour)
buttons
Selects the coloured
items on the screen.
6 Input cursor
Press c/d to move the
cursor when highlighted.
7 Input field
The text you enter is
displayed as you type
it in.
8 Character
Input characters by
using these buttons.
9 ?
Put a line break.
0 Clear
Erases the character
string.
• When the cursor is
somewhere in a line:
The character string to
the right of the cursor
will be erased.
• When the cursor is at
the right end of a line:
The entire line will be
erased.
Q Delete
If the cursor is at the
right end of a line,
this erases text one
character at a time.
• You can also delete
text by pressing 6
on the remote control
unit.
NOTE
• Depending on the application, there may be a different software keyboard than the one
indicated above.
• When inputting letters in MHP services, use the numeric buttons on the remote control
unit (858 series only).
Quick guide