Flat Panel Television User Manual

26
Specifications
Appendix
• Typical time for power output decrease of about one-half assuming continuous use in a room with normal lighting, normal
brightness and temperature at 77°F/25°C.
• As part of policy of continuous improvement, SHARP reserves the right to make design and specification changes for
product improvement without prior notice. The performance specification figures indicated are nominal values of production
units. There may be some deviations from these values in individual units.
Item Model: LC-26SB27UT
LCD panel 26” Class (26 Diagonal)
Active Matrix (a-Si TFT LCD)
Resolution 1,049,088 pixels (1366 x 768)
TV
Function
TV-standard (CCIR) American TV Standard ATSC/NTSC System
Receiving
Channel
VHF/UHF VHF 2-13ch, UHF 14-69ch
CATV 1-135ch (non-scrambled channel only.)
Digital Terrestrial
Broadcast (8VSB)
2-69ch
Digital Cable
*1
(64/256 QAM)
1-135ch (non-scrambled channel only.)
Audio multiplex BTSC System
Audio out 5.0W x 2
Terminals Rear INPUT 1 AV in, S-VIDEO in
INPUT 2 AV in
INPUT 3 COMPONENT in, Audio in (Share with INPUT 2)
INPUT 4 HDMI in with HDCP, Audio in
INPUT 5 HDMI in with HDCP
INPUT 6 15-pin mini D-sub female connector, Audio in (φ 3.5 mm jack)
DIGITAL AUDIO
OUTPUT
Coaxial Digital audio output x 1 (PCM/Dolby Digital)
ANT/CABLE 75 Ω Unbalance, F Type x 1 for Analog (VHF/UHF/CATV)
and Digital (AIR/CABLE)
OSD language English/French/Spanish
Power Requirement AC 120 V, 60 Hz
Power Consumption 67 W (0.7 W Standby with AC 120V)
Weight TV + stand 20.7 Ibs./9.4 kg
TV only 17.4 Ibs./7.9 kg
Dimension
*2
(W x H x D)
TV + stand 26
1
/
32
x 20 x 9
9
/
16
inch
TV only 26
1
/
32
x 18
13
/
64
x 3
61
/
64
inch
Operating temperature +32°F to +104°F (0°C to +40°C)
*1
Emergency alert messages via Cable are unreceivable.
*2
The dimensional drawings are shown on the inside back cover.
The password is
NOTE
• As a precautionary measure, make a note of your
password above, cut it from this manual, and keep it in a
safe place.
.
CLEARING THE PASSWORD
If you forget the password, clear the password using the following procedure.
1
Press and hold both VOL – on the TV and press 0 on the remote
control simultaneously for a few seconds until
“
Lock
”
menu appears on
the screen.
2
Now the old password was cleared. You can set the new password.
37P0131A.indb 2637P0131A.indb 26 5/29/09 10:44:15 AM5/29/09 10:44:15 AM