User Manual

46
Before Using the Handset
: If you select an access point not protected by
security, it is automatically connected.
: If you select an access point protected by
security, enter the password (security key).
: WPS compatible access points can be easily
registered. Select an item in Setup and
register an access point.
: To register access points manually: [ADD
NETWORK]
/enter the network SSID/set
security
/[Save]
: Alternatively, select [AOSS] to connect to an
access point. Follow the instructions on the
screen and operate after this step.
1
In the home screen, [R]/
[Settings]/[Wi-Fi]/[z]/
[Advanced]
2
Select an item
 Network notification: Set whether to display a
notification icon when an open network is
detected.
Ʀ Enable the Wi-Fi function before setting it.

Wi-Fi sleep policy: Set when to switch the
Wi-Fi function to the sleep mode.

MAC address: Confirm the MAC address.

IP address: Confirm the IP address.
1
In the home screen, [R]/
[Settings]/[Wi-Fi]
2
Select the connected access
point
/[Forget]
: Disconnect with the password retained.
Tethering function that connects Wi-Fi
compatible devices to the Internet by using the
handset as a Wi-Fi access point is available.
You can connect to up to five Wi-Fi compatible
devices simultaneously.
1
In the home screen, [R]/
[Settings]/[Network settings]/
[Tethering]
2
Select an item

Wi-Fi tethering: Enable the Wi-Fi tethering.
Ʀ Check the details of the precautions before
use.

Configure Wi-Fi hotspot: Set the Wi-Fi
tethering settings such as network SSID and
security.

Help: Display Help information.
When you select an access point and connect to
it with a wrong password (security key), [Avoided
poor Internet connection] or [Connected
(Limited)] is displayed. Confirm the password
(security key). When [Avoided poor Internet
connection] or [Connected (Limited)] is
displayed after entering the correct password
(security key), you may not have acquired the
correct IP address. Connect to the access point
again after confirming signal status.
The registration process using WPS takes a
few minutes. After completion of the registration
of the access point, check that the proper
connection to the access point is acquired.
As for the manual registration of an access
point, this function supports WEP, WPA/WPA2
PSK, 802.1xEAP as the security setting.
Detailed settings
Disconnecting
Wi-Fi tethering