User's Manual

350
e16_dr20_7e.fm
[350/358]
Data Management
Actual operational methods will differ with each i-appli software
application.
Control devices from a distance of up to approximately 4 m (Distance will
vary depending on the device, the ambient brightness and other factors).
Use iC communication to send and receive data to and from other
FOMA terminals which also support iC communication function.
During iC communication, the FOMA terminal status is the same as
when outside the service area, such that making/receiving calls, i-mode,
and data communications are not possible.
iC communication is not available while a call is in progress or the IC
card is locked.
For an image, i-motion, Melody, PDF, or Decome-Anime Template in the
Data box, Sending and receiving all data items is not available. For other
than those above, data that can be sent and received or operations when
various lock functions are set are same as for Ir communication
(nP. 346).
For details on starting iC communication from i-appli nP. 277
Use while placing the b mark of receiver’s FOMA terminal on that of
sender’s FOMA terminal as shown.
Do not move the FOMA terminal until all data are sent and received.
Sending and receiving data may be difficult depending on the other
party’s FOMA terminal. In such case, make the clearance between the
b mark closer or farther, or move them up/down/left/right alternately.
During iC communication, FOMA terminal called LED flashes
(nP. 100).
Data communication via iC communication is not available while
charging.
When in the Self mode, the Ir remote control function cannot be used.
Depending on the device, operation may not run properly.
Remote control operation may not run properly directly under
fluorescent lights, near other equipment using infrared signals, or in
areas of direct sunlight.
iC communication
15°
Approx. 4 m
15°
Infrared port
Precautions for using iC communication function
b mark
dr20_E.book 350 ページ ２００９年４月２４日 金曜日 午後４時２８分