User Manual

Remote Operations

2. Answering

Machine

Note: You can also call the machine and perform remote operations when the

reception mode is set to FAX. In this case, when you call the machine, press

immediately after it answers (before you hear the fax tone), and then

continue from Step 2 above.

Comments:

♦ When a remote command is accepted by the machine, you will hear one

beep. If an incorrect command is entered, you will hear four beeps. In the

latter case, re-enter the correct command.

♦ When entering a command, do not pause longer than 10 seconds between

each digit. If you do, you will hear a 4-beep error signal and the digits

entered up to that point will be cleared. In this case, re-enter the command

from the beginning.

♦ If you pause for longer than 10 seconds before entering a command, or

make two errors while entering your remote code number, the line will be

disconnected. (This prevents unauthorized people from attempting to

guess your remote code number.)

♦ A.M. mode: , , and .

♦ FAX mode: , , and .

♦ TEL mode: , , and .

Caution: If you select TEL mode, you will not be able to change the

reception mode again.

♦ TEL/FAX mode: , , and .

8 1

8 3

8 4

Changing the fax reception mode

Select a new reception mode by pressing the keys as follows:

Other remote operations

After listening to your messages, you can perform any of the following

operations by pressing the appropriate keys on the telephone.

Note: The following commands cannot be entered while messages are being

played back. If you do not want to wait until playback ends to enter a

command, first stop playback by pressing and , and then enter the

command.