User`s guide

Components 13
E-EQ-MX1RG-D MX1 Reference Guide
Power On and Off
Turn On the MX1
Press the Power button until the display turns on. The power button is located at the bottom of the
keypad.
Figure 1-10 Location of the Power Button
When the MX1 is powered on, the display will begin scrolling power-on information as software
and drivers are loaded. When the display has stopped scrolling and a DOS prompt is displayed or
an application begins, the power on sequence is complete. (The Power Key can be disabled – see
Power Key in BIOS Setup.)
Turn Off the MX1
Hold the Power button down. The unit will emit three short beeps and one long beep. After the
long beep the MX1 will power down. The Power button and the display will turn off.
Note: Quickly tapping or releasing the Power button prior to the one long beep signal will
place the MX1 in Suspend mode (if Suspend is enabled, see Power Key in BIOS Setup to
configure the Suspend function).
Troubleshooting
The MX1 will not turn off – force a Power Off by holding the Power key down for 15 seconds
and the MX1 will power off. Locate and correct the problem before powering the MX1 back on –
e.g. very low battery power, radio conflict, unexpected software application result, etc.