User`s guide

NET.CFG Parameters 115
E-EQ-MX1RG-D MX1 Reference Guide
AWCLEAP
AWCLEAP is a DOS utility used to set LEAP (Light Extensible Authentication Protocol)
authentication for Cisco 350 radios. The SETLEAP.BAT file runs the AWCLEAP utility. To set
LEAP, type setleap <username> <password> at the c:\pctcp prompt.
The CLEAR.BAT file is used to clear the LEAP username and password. To clear LEAP, type
clear at the c:\pctcp prompt.
Note: This version of the MX1 DOES NOT use the SETLEAP2.BAT and CLEAR2.BAT files.
FragThreshold
Packet size to start fragmenting.
Default: FragThreshold 2312
RTSThreshold
Packet size to start sending RTS/CTS.
Default: RTSThreshold 2312
DataRateX
To set a data rate other than 11 MB default uncomment rate desired and all data rates less than
that rate. Example to set for 5.5MB data rate uncomment the DataRate1, DataRate2 and
DataRate3.
1 Mbps supported data bit rate
DataRate1 0x02
2 Mbps supported data bit rate
DataRate2 0x04
5.5 Mbps supported data bit rate
DataRate3 0x0B
11 Mbps supported data bit rate
DataRate4 0x16
RefreshInterval
Inactivity time to check association with AP
RefreshInterval 10000
PowerSaveMode
PowerSaveMode "FASTPSP"
Fast Power Save Mode
MaxPowerSave
Maximum power save mode
MaxPowerSave "ON"