User Manual

32
04/1/19 CD-ES9(U)3.fm
TINSEA055AWZZ
CD-ES9
Advanced Features



Headphones



Before plugging in or unplugging the headphones, reduce the vol-
ume.



Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.



Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.



General



CD player
Symptom Possible cause



The clock is not set to the
correct time.



Did a power failure occur? Reset
the clock. (Refer to page 15.)



When a button is pressed,
the unit does not respond.



Set the unit to the power stand-
by mode and then turn it back on.



If the unit still malfunctions, reset
it. (Refer to page 33.)



No sound is heard.



Is the volume level set to "0"?



Are the headphones connected?



Are the speaker wires discon-
nected?
Symptom Possible cause



Playback does not start.



Is the disc loaded upside down?



Playback stops in the mid-
dle or is not performed
properly.



Does the disc satisfy the stan-
dards?



Is the disc distorted or
scratched?



Playback sounds are
skipped, or stopped in the
middle of a track.



Is the unit located near excessive
vibrations?



Is the disc very dirty?



Has condensation formed inside
the unit?