Operation Manual, User's Manual

10-103
SETTING MODE►SYSTEM SETTINGS
Receive Settings
Configures the settings for Internet fax.
Auto Receive Reduce Setting
When a fax is received that includes printed information such as the sender's name and address, the received image is
slightly larger than the standard size. This setting is used to automatically reduce the image to fit the standard size.
Factory default settings: Enable
2-Sided Printing of Received Data
This is used to have received faxes printed on both sides of the paper.
When this setting is enabled and a fax consisting of 2 or more pages is received (the pages must be the same size), the
pages are printed on both sides of the paper.
Factory default settings: Disable
Set Address for Data Forwarding
When the machine cannot print a received fax, the fax can be forwarded to another machine. This setting is used to
configure the address of the other machine.
Forwarding to
Enter the forwarding address (maximum of 64 characters).
Direct SMTP
Select this to enable forwarding when direct SMTP is used.
Factory default settings: Disable
Add Hostname or IP Address.
Select this to separately enter a host name or IP address.
Factory default settings: Disable
Hostname or IP Address
Use this setting when "Add Hostname or IP Address." is enabled. Enter the host name or IP address (maximum of 64
characters).
Letter Size RX Reduce Print
This program is not available in USA
When a letter-R (8-1/2" x 11"R) size fax is received, this setting reduces the fax to A4R size.
When this setting is enabled, A4R size faxes are also reduced.
Factory default settings: Disable
If Auto Receive Reduce is disabled, the edges of the image outside the standard size will be cut off.
However,
the image will be clearer because it will be printed at the same size as the original.
Standard sizes are sizes such as A4 and B5 (8-1/2" x 11" and 5-1/2" x 8-1/2").
Multiple forwarding addresses cannot be stored.