Operation Manual, User's Manual

11-3
TROUBLESHOOTING►GENERAL PROBLEMS
THE ORIGINAL MISFEEDS
(AUTOMATIC DOCUMENT FEEDER)
Is too much paper loaded into the document feeder tray? 11-9
Is the original a long original? 11-9
Is the original on thin paper? 11-9
Is the original on heavy paper? 11-9
Is the feed roller dirty? 11-9
MULTIPLE ORIGINALS ARE FED AT
THE SAME TIME AND CANNOT BE
LOADED CORRECTLY
(AUTOMATIC DOCUMENT FEEDER)
Are your originals warped or folded? Are you using a pasted originals? 11-9
THE EJECTED MANUSCRIPTS ARE
NOT ALIGNED NEATLY
(AUTOMATIC DOCUMENT FEEDER)
Is the manuscript set correctly? Depending on the condition of the
original, the type of paper, the temperature at the time of use, and the
humidity environment, the ejected originals may not be aligned neatly.
11-10
THE PAPER MISFEEDS
Is a torn piece of paper remaining in the machine? 11-10
Is too much paper loaded in the tray? 11-10
Are multiple sheets feeding at once? 11-10
Are you using paper that is not within the specifications? 11-10
Are the bypass tray guides adjusted to the width of the paper? 11-10
Is the bypass tray extension guide pulled out? 11-10
Is the bypass feed roller dirty? 11-10
Is A5/A6 (5-1/2" x 8-1/2") size paper loaded? 11-10
Is the paper size specified? 11-10
Did you add paper to the tray? 11-10
Are you using punched paper? 11-11
Are you using label sheets that cannot be used? 11-11
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
11-11
PAPER DOES NOT FEED FROM
THE PAPER TRAY
Is the paper loaded correctly into the paper tray? 11-11
Has the tray been prohibited in some modes (copy, print, fax, image
send, document filing)?
11-11
I DON'T KNOW HOW TO CHANGE
THE PAPER SIZE
Set the paper size used in each tray in the tray settings. 11-11
THE OUTPUT IS NOTICEABLY
CURLED AND UNEVEN
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
11-12
THE IMAGE IS SKEWED ON THE
PAPER
Is too much paper loaded into the bypass tray? 11-12
Are the bypass tray guides adjusted to the width of the paper? 11-12
Are the original guides adjusted to the width of the paper? 11-12
The original is scanned skewed. 11-12
LINES APPEAR IN THE IMAGE
Are the scanning areas of the document glass or automatic document
feeder dirty?
11-12
Is the bypass feed roller dirty? 11-12
Did you execute Dark Streak Reduction of system setting? 11-12
SMUDGES APPEAR ON PRINTED
OUTPUT
Are you using paper that is not within the specifications? 11-13
Are you printing on pre-punched paper? 11-13
Does a message appear indicating the need for maintenance? 11-13
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
11-13
Problem Check Page
?