Specifications

5-19
5
SADDLE STITCH FINISHER
■ Staple sort mode
Collated sets of prints or copies will be stapled and delivered to the offset tray. When saddle stitching is selected,
the prints or copies will be stapled at the center and delivered to the saddle stitch tray. The stapling positions,
orientation, paper size for stapling, and stapling capacity are shown below.
Stapling positions
Top left corner of
printouts
Center left two
positions of
printouts
Lower left corner
of printouts
Portrait orientation
Landscape orientation
Available paper sizes: 8-1/2"
x 11", A4 and B5
Stapling capacity: Up to 50
sheets for any sizes
Same as above
Same as above
Saddle stitch on
centerfold line.
Paper in the portrait direction
cannot be saddle stitched.
Available paper sizes: 11" x
17", 8-1/2" x 11"R, A3, B4,
and A4R
Stapling capacity: Up to 10
sheets for any sizes
Available paper sizes: 11" x 17",
8-1/2" x 14", 8-1/2" x 13", 8-1/2"
x 11" R, A3, B4, and A4R
Stapling capacity: Up to 50
sheets for 8-1/2" x 11"R, A4R
and B5R, and up to 25 sheets
for other sizes
Available paper sizes: 11" x 17",
8-1/2" x 14", 8-1/2" x 13", 8-1/2"
x 11" R, A3, B4, and A4R
Stapling capacity: Up to 50
sheets for 8-1/2" x 11"R, A4R
and B5R, and up to 25 sheets
for other sizes
Available paper sizes: 11" x 17",
8-1/2" x 13", A3, and B4
Stapling capacity: Up to 25
sheets for any sizes
■ Hole punching (only if a punch module is
installed)
If the saddle stitch finisher is equipped with a hole
punch module, printed paper can be hole punched
and delivered to the offset tray. Saddle stitching and
hole punching cannot be selected at the same time.
If the hole punching function is set for a paper size
that is not available for hole punching, prints or
copies will be made without hole punching. (For
paper sizes available for hole punching, see page
5-18.) When using the hole punching function in the
copy mode, place the original so that the top of the
original is positioned to the rear side of the machine.
If not, the holes will be incorrectly positioned. (See
“Standard original setting orientation” on page 8 of
the “Operation manual (for copier)”.
<Example>
{Original 1} {Punch positions}
{Original 2} {Punch positions}
■ Saddle stitch function
The saddle stitch finisher can automatically place
two staples for centerline binding of prints or copies
and fold them along the centerline.
<Example>