Specifications

87
7
WHEN AN ALARM SOUNDS AND A
WARNING MESSAGE IS DISPLAYED
Alarms and display messages alert you to the condition of the machine during operation. If one of the following
messages appears, respond as indicated in the table.
Message screen (Alarm) Cause and solution Page
COMMUNICATION ERROR
OCCURRED.FAX
TRANSMISSION WAS
SUSPENDED.
The transmission did not end normally due to a
communication error and a Transaction Report was
printed.
→ Check the Transaction Report and then try the
transmission again.
-
(MAINTENANCE REQUIRED.) Maintenance is required.
→ Contact your dealer.
-
PLEASE RETURN XX
ORIGINALS TO THE
DOCUMENT FEEDER, THEN
PRESS [START].
A misfeed occurred in the RSPF while the original was
being scanned.
→ Reload the indicated original pages.
-
OPEN TRAY X AND ADD XXX
PAPER.
(TYPE: XXXXX)
Printing cannot take place because the machine is out
of suitable paper.
→ Add the indicated paper.
operation manual for
copier
REMOVE PAPER FROM THE
UPPER TRAY.
The job separator tray is full.
→ Remove the printed pages.
-
REMOVE PAPER FROM THE
TOP TRAY.
The top tray is full (when a finisher is installed).
→ Remove the printed pages.
-
(TONER SUPPLY IS LOW.) Little toner remains in the toner cartridge.
→ Replace the toner cartridge.
operation manual for
copier
CHANGE THE TONER
CARTRIDGE.
The toner cartridge is out of toner and the received
document cannot be printed.
→ Replace the toner cartridge.
THE MEMORY BECOMES
FULL. (Pg.No.XX)
SEND SCANNED DATA? OR
CANCEL THE JOB?
The memory became full while the original was being
scanned.
→ Send only the pages that were already scanned, or cancel
the entire transmission.
15
POLLING IS NOT POSSIBLE
WITH THE AVAILABLE
MEMORY.
Polling is not possible because there is not enough
space in memory.
→ Try polling again after currently stored jobs are completed.
33
MANUAL RECEIVE IS
DISABLED.
DUE TO OUT OF MEMORY.
Manual reception was not possible because there was
not enough free space in memory.
→ Try manual reception again after currently stored jobs have
been completed.
-
CLOSE THE XXXXX COVER. The indicated cover is open.
→ Close the indicated cover.
-
CLOSE THE DOCUMENT
FEEDER.
CALL FOR SERVICE.
CODE:XX XX.
The self-diagnosis function has activated and
automatically stopped operation. An error code appears
in xx-xx.
→ Turn off the power and then turn it back on. If the same
message still appears, contact your authorised service
representative.
-