Specifications

98
KEY OPERATOR PROGRAMS
INITIAL RESOLUTION SETTING
This setting is used to select the default resolution
setting for fax mode. Selections are [STANDARD],
[FINE], [SUPER FINE], and [ULTRA FINE]. When the
resolution is set to [FINE], [SUPER FINE], or [ULTRA
FINE], [HALF TONE] can also be selected. To select
HALF TONE for the selected resolution setting, touch
the [HALF TONE] key so that it is highlighted.
INITIAL EXPOSURE SETTING
This program is used to set the default exposure for
scanning in fax mode.
[AUTO] or [MANUAL] can be selected for the
exposure. When [MANUAL] is selected, the exposure
can be adjusted to one of five levels. [1] is the lightest
level and [5] is the darkest level.
OWN NUMBER AND NAME SET
Use this program to enter, edit, or delete the fax
number of the machine and the sender's name. The
entered name and number are printed at the top of
each fax page that is sent. The number is also used as
a passcode when performing polling reception.
You can check your entries by printing out the Sender
List in the custom settings. (p.86)
1
Touch the [ENTER] key.
The new entry screen appears.
2
Touch the [NAME] key and enter the
sender's name.
The sender's name entry screen appears.
Up to 20 sender's names can be entered.
A maximum of 22 characters can be entered for a
sender's name.
To enter characters, see "ENTERING CHARACTERS"
on page 81.
3
Touch the [FAX No.] key and enter the fax
number.
Enter up to 20 digits for the number using the numeric
keys.
To enter a "+", press the " " key.
To enter a hyphen, touch the [PAUSE] key. To enter a
space, press the [SPACE] key.
If you make a mistake, press the [CLEAR] key ( ) and
re-enter the correct digit.
4
Touch the [OK] key.
5
To exit, touch the [EXIT] key.
• To enter another sender, touch the [NEXT] key.
1
Touch the [AMEND/DELETE] key.
2
Touch the sender key that you wish to edit
or delete.
3
Touch the keys that wish to edit or delete.
• To edit sender information, follow the same steps as
when storing the sender.
• To delete a sender, touch the [DELETE] key in the
upper right corner of the screen and then touch the
[YES] key in the message screen that appears. (To
cancel the deletion, touch the [NO] key.)
PAUSE TIME SETTING
This setting is used to select the duration of the pause
that is inserted in a destination fax number when the
[PAUSE] key is pressed while dialling or storing the
number.
Any number of seconds from 1 to 15 can be selected.
• HALF TONE cannot be selected for
STANDARD resolution.
• For information on each of the resolution
settings, see page 21.
If multiple senders have been programmed
and a sender is not selected, the sender
with the lowest control number is
automatically selected.
Entering the sender's name and number
You can also program only a name or only a
number as a sender.
Note
Note
KEY OPERATOR PROGRAMS
OWN NUMBER AND NAME SET
ENTER AMEND/DELETE
OK
Note
Editing or deleting a sender