Service manual

4-14
CHAPTER 4 REPLACEMENT OF PARTS
K. Board PRP/Top cover handle
(1) Detach the control panel assembly. (See Section "J. Controller panel assy".)
(2) Release two claws A, as illustrated in Figure (2), and remove frame OP1, lever lock 2 and
spring compression 3.
(3) Release two claws B by forcing in the flat-tipped screwdriver (Tool No. 3), and remove the
cover assembly OP4 and spring torsion 5.
(4) Release two claws C of the cover assembly OP 4, as shown in Figure (3), and remove Board
PRP6 and cable 7.
Board PRP/ Top Cover Handle
2
5
6
7
3
1
4
Claws A
Claws A
Claws B
Claws C
Figure (3)
Figure (1)
Figure (2)