Service manual

7-49
CHAPTER 7 TROUBLESHOOTING PROCEDURES
(9-2) An error occurs in the operation of ID Unit Down
Load in installing/removing of
ID unit
Greasing of right and left up-
down link levers
Assembled state of right and
left up/down link levers
At least the cyan ID is
installed.
(9-2-1) Check of load in the descent
Confirmation Items
Confirmation Tasks
Check to see if any abnormal load is felt in installing or removing
the ID unit.
Check to see if the slant parts of the link levers are properly
greased.
Check to see if any part around the link levers is obstructing
their motion.
Check to see if there is no cyan ID installed when the N- color
mode is set.
Action at NG
Replace the ID unit or
modify the right and left
side plates.
Apply grease.
Reassemble them
correctly.
Install a dummy cyan
ID or regular cyan ID..
(9-2-2) Installed state of ID unit