- SHARP Operation Manual AR-BC260

4-6
SETTING ORIGINALS
When using the reversing single
pass feeder
1
Adjust the original guides to the size of the
originals.
2
Place the originals face up in the
document feeder tray.
Set the originals all the
way into the feed slot.
Do not exceed the
maximum height line
marked on the original
guide.
When using the document glass
Open the document cover, place the
original face down on the document glass,
and then gently close the document cover.
[ How to place the original ]
Place the original in the appropriate position shown
below according to its size. ( Center the original on
the centering scale.)
* When the reversing single pass feeder is used, these sizes are only supported for one-sided originals.
NOTES
Do not place any objects under the original size
detector, because they may damage it or the
original size may not be detected properly.
If an original has been placed in the document
feeder tray of the reversing single pass feeder,
remove it. Otherwise the original in the document
feeder tray will be scanned instead of the original
on the document glass.
Original size detector
R
R
8½x14
or B4
11x17 or A3
8½x11 or A4
8½x11
or A4
5½x8½
or A5
Original scale
Centering scale
Original scale
Centering scale
NOTE
Original size detection function
One of the four groups of standard original sizes shown below can be selected for detection by the original size
detection function. The factory default setting is "INCH-1 (AB-1)". The setting can be changed using "ORIGINAL
SIZE DETECTOR SETTING" in the key operator programs. (Page 11 of the key operator's guide.)
Group
Detectable original sizes
Document feeder tray (for reversing single pass feeding) or document glass
1 INCH - 1 11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"*
2 INCH - 2 11" x 17", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2"*
3 AB - 1 A3, A4, A4R, A5, B4, B5, B5R
4 AB - 2 A3, A4, A4R, A5, B5, B5R, 8-1/2" x 13"
ApollonII_general-copy_SEC.book 6 ページ 2004年9月6日 月曜日 午後4時57分