Flat Panel Television User Manual

50
Other viewing options
Picture and still image
You can display two same-sized pictures – one moving
and one still.
Press FREEZE.
• A moving image displays on the left screen and
a still image displays on the right screen. The
still image is one frame captured from a moving
image at the moment you press FREEZE.
Update the still image by pressing ENTER.
• Each time you press ENTER, the image on the
right screen updates.
Press FREEZE to exit still image.
NOTE
• This function does not work in INPUT 4 (HDMI) and INPUT
5 (DVI-I).
• When this function is not available, “No displaying still
image available.” will display.
• The still image automatically goes out after 30 minutes.
• If you are using FREEZE and a broadcast activates the
V-CHIP BLOCK, FREEZE will cancel and a block message
will appear.
FREEZE
1
2
3
Presetting remote control function
You can operate the connected AV products (AV
Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD)
using the presetting manufacturer function for your
remote control unit.
Presetting manufacturer codes
Press FUNCTION until the LED for your
device lights up.
After the LED for your device lights up, if you
press FUNCTION and DISPLAY and enter
the code registration mode, the LED will
blink.
Press 0 – 9 to enter the manufacturer code.
(See page 51.)
• Preset mode is finished once the LED no longer
lights up.
1
2
3
After registering the code, the LED will stop
blinking then turn off after one second. (If
you perform an incorrect operation, the LED
will blink quickly then turn off.)
4
LC-26/32GA5U(E)(NOM)-50 04.12.21, 2:13 PM50