user manual

: Jan. 9 2004
1
AR-CF2 OPERATIONAL DESCRIPTION 4 - 5
The correspondence between the punching/stapling mode settings and LEDs is shown below.
∗ ●: means "Lit."
5. LED indication on operator panel
Note: For LED status, each blank means "not lit."
Punch
LED
Staple mode LEDs
Stapling mode
LED1 LED2 LED3 LED4
❍●❍❍❍1-point stapling at back
❍❍●❍❍2-point stapling
❍❍❍●❍1-point stapling at front
❍❍❍❍●Saddle stapling (saddle stitching)
●❍❍❍❍Punching
●●❍❍❍Punching + 1-point stapling at back
●❍●❍❍Punching + 2-point stapling
●❍❍●❍Punching + 1-point stapling at front
Status Cause Explanation
START LED
MODE LED
Red Green
Empty tray The selected MODE LED is lit.
Inserter problem
Finisher problem
Paper jam in inserter Lit The LED of the selected mode is lit.
Paper jam in finisher Lit The LED of the selected mode is lit.
Inserter alarm The LED of the selected mode is lit.
Finisher alarm The LED of the selected mode is lit.
Open inserter cover The LED of the selected mode is lit.
Open finisher cover The LED of the selected mode is lit.
Offline operation disabled
Inserter tray specified stapling
mode non-usable
Punching non-usable
The LED of the selected mode is lit.
Operation mode Stapling disabled
Punching disabled
The LED of the selected mode is blinking.
Full tray (considered as a kind of
finisher alarms)
The LED of the selected mode is lit.
Other
Paper-loaded tray
(Operable)
Lit
The LED of the selected mode is lit.
Paper-loaded
tray(Non-operable)
Inserter problem Lit
Finisher problem Lit The LED of the selected mode is lit.
Paper jam in inserter Lit
Paper jam in finisher Lit The LED of the selected mode is lit.
Inserter alarm Blinking The LED of the selected mode is lit.
Finisher alarm Blinking
The LED of the selected mode is blinking.
Paper-loaded tray
(Non-operable)
Open inserter cover The LED of the selected mode is lit.
Open finisher cover The LED of the selected mode is lit.
Incompatible paper size
A non-usable paper size "A4
lateral," etc. is added when
the saddle mode is selected:
Extra size
Blinking
The LED of the selected mode is lit.
Offline operation disabled
Inserter tray specified stapling
mode non-usable
Punching non-usable
The selected mode is non-
usable.
The LED of the selected mode is blinking.
Operation mode Stapling disabled
Punching disabled
The selected mode is
disabled.
The LED of the selected mode is blinking.
Full tray (considered as a kind of
finisher alarms)
The tray corresponding to
the selected mode is full.
Blinking
The LED of the selected mode is blinking.
Over loaded Blinking The LED of the selected mode is blinking.
Paper loaded in the finisher
intermediate process tray
Blinking
The LED of the selected mode is lit.
Other Main unit status "operation
disabled," finisher status
"non-operable," etc.
The LED of the selected mode is lit.
Waiting for start of
offline operation
After a user presses the
START switch
Blinking
The LED of the selected mode is lit.
In offline operation Blinking The LED of the selected mode is lit.
1
1
1
1
1