Specifications

MX-3610N MAINTENANCE 8 – 5
3 Transfer
section
Primary
transfer unit
1 Separation pawl – ✕✕✕✕✕✕Replace as needed.
2 Primary transfer belt – When replacing, apply
KYNAR powder.
3 Secondary drive
transmission gear
– 
4 Primary transfer belt
drive roller
– 
5 Primary transfer belt
follower roller
– 
6 Primary transfer belt
tension roller
– 
7 Registration backup
roller
– 
8 Y auxiliary roller – 
9 PTC backup roller – 
10 Primary transfer
roller
– ✕✕✕✕✕✕Replace as needed.
11 Transfer cleaner
seals F/R
– ✕✕✕✕✕✕Replace as needed.
12 Primary transfer belt
cleaner blade
– 
13 Primary transfer
toner reception
blade
– ✕✕✕✕✕✕Replace as needed.
14 Primary transfer
operation mode
detector
– 
4 Transfer
section
Secondary
transfer unit
1 Secondary transfer
belt follower roller
––– ––
2 Secondary transfer
belt
––– –– Never use alcohol or
solvents for cleaning..
3 Secondary transfer
belt drive roller
––– ––
4 Secondary transfer
backup roller
––– ––
5 Secondary transfer
belt tension roller
––– ––
6 Secondary transfer
roller
–––✕ ––✕ Replace as needed.
7 Secondary transfer
drive gea
r
–––✕ ––✕ Replace as needed.
8 Separation cam – – – ✩ ––✩ When replacing, apply
UKOG-0299FCZZ to the
shaft section.
9 Secondary transfer
frame
–––✩ ––✩ When replacing, apply
UKOG-0299FCZZ to the
shaft section.
5 Other 1 PTC unit  
2 Image density
sensor/Registration
sensor/ Standard
reflection plate
– Remove dirt from the light
emitting/receiving
sections (transparent
plastic sections) of the
sensor and the standard
reflection plate (gray
plastic section) with dry
waste cloth. *
1
6 LSU section LSU 1 Dust-proof glass  Use the LSU cleaning rod.
Other 2 Cleaning base ✕ Replace every time the waste toner
box is replaced.
Attached to the waste
toner box. (2 pcs.) /
Replace when the waste
toner box is replaced, or
at 100K, or 2 years of use.
7 Manual
paper feed
section
Manual paper
feed unit
1 Paper feed roller ✕ Replace at 80K of each
paper feed counter or
after 2-year use.
2 Separation roller ✕ Replace at 80K of each
paper feed counter or
after 3-year use.
3 Torque limiter ✕ ✕✕✕✕✕✕
4 Transport roller 9 ✕ 
5Sensors ✕ ✕✕✕✕✕✕
– Paper guides  
Section/Unit
work sequence
Name Unit name
Work
sequence
Part name
When
calling
80
k
160
k
240
k
320
k
400
k
480
k
Remark