Specification

29
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] •
www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both
to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well
as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any
recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
Effective Date:
October 2013 -Rev. 12/4/2013-
Void After: October 2014
Product:
Lead Free Plumbing Products
File No. 6544
Issued To:
CASH ACME/RELIANCE WORLDWIDE
2400 7TH AVE SW
CULLMAN, AL 35055
Identification:
Each product shall bear permanent and legible markings to identify the manufacturer.
This marking shall be the trade name, trademark, or other mark known to identify the
manufacturer. The product and/or product packaging may also bear the term "Lead
Plumbing Law", "Complies with Lead Plumbing Law", or either “Lead Free” or “Low Lead”
above or in close proximity to the appropriate IAPMO R&T certification mark, or the
term "Certified by IAPMO R&T". The product packaging may also bear a grey dot, a check
mark with circle, or any other home centers marking requirements.
Characteristics:
Products may include any pipe, pipe fitting, solder, flux, or other plumbing products
providing water for human consumption. Products listed below are to be installed in
accordance with the manufacturer's instruction. These products have been verified with
weighted average lead content <=0.25%; Solder and flux lead content <=0.2%.
Products listed on this certificate have been tested by an IAPMO R&T recognized
laboratory. This recognition has been granted based upon the laboratory's compliance to
the applicable requirements of ISO/IEC 17025.
Products are in compliance with the following standard(s):
Section 1417(d) of the Safe Drinking Water ActThe lead content requirements of Section
116875 of the California Health & Safety Code
NSF/ANSI 372-2010
For a complete list of compliant models and the most up to date listing, please visit
http://pld.iapmo.org/file_info.asp?file_no=0006544