Instruction Booklet & Warranty Information

13sharkclean.com
English
English
IMPORTANT: Loss of suction may
occur if foam filters are not cleaned
every 3 months. Rinse and allow to
air dry completely. Also, tap loose dirt
off filter between washes as needed.
Foam filters may appear dirty after
use - this is normal.
Fig. 18 Fig. 19
COMPONENT MAINTENANCE SCHEDULE
Rinse and air dry every 3 months under normal use.
Empty each time you vacuum.
Pre-Motor Foam Filter
Dust Cup
Rinse and air dry every 3 months under normal use. Pre-Motor Felt Filter
Clean once every 2 years or as needed.
Post-Motor HEPA Filter
1
2
3
4
CLEANING THE PRE-MOTOR FILTERS
1 Remove the dust cup.
2 Pull the 2 filters out from the top of the motor base.
(Fig. 21)
3 Rinse the filters thoroughly in lukewarm water until the
water runs clear.
DO NOT put the filter in the washing machine or
dishwasher.
NOTE: The material in the filter will discolor over time. This
is NORMAL and will not affect the performance of the filter.
4 Squeeze out excess water and let air-dry for at least 24
hours before replacing. Do not use a hair dryer or other
heating methods to dry.
5 Place the felt filter in first, then the foam filter.
6 Replace the dust cup.
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time you vacuum and
periodically during cleaning, when the dust cup appears full.
1 Undo the latches on the sides of the dust cup by lifting
them up and outwards to remove the dust cup from the
motor base. (Fig. 18)
2 Hold the dust cup over a trash receptacle and press the
bottom door release button. (Fig. 19) Tap gently to empty
contents. Press the door shut again until it clicks.
3 If needed, turn the dust cup upside down over the trash
receptacle and press the top door release button.
(Fig. 20) Tap gently to remove contents.
Use a dry cloth or paper towel to remove debris stuck to the
screen filter inside the dust cup. Press the door shut again
until it clicks.
4 Replace the dust cup on top of the motor base. Hook the
two latches onto the tabs on the sides of the dust cup and
push down to lock.
Screen
Filter
Fig. 20
Fig. 21
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter
Maintenance